Just finished this M20J interior-pics are attached.

Cut lower panels and replaced with FAA grade .060 Boltaron thermo plastic-no screws! Fastened with 3M Dual lock from the airplane frame. This provides easy access for maintenance and eliminates unsightly holes that tend to spread with age and vibration. Elimination of side arm rests have has expanded the tight Mooney cockpit.

High grade Vinyl Flite floor(same stuff used on air carriers) backed up with 1/4 inch ensolite for sound proofing/insulation/comfort. I like the clean look!

Glare shield repaired and covered with steam stretched leather with leading edge stitching-huge improvement!

Project completed in a week-on to the next one...

Rico
Flying Bull Frog LLC

Very nice. I like that black leather binding. Everything very clean.

Very nice ! Can you share where did you buy the materials and the cost .
Suggestions ?
Great looking !
Jackob

Jackcob
Sorry, looks like I did not respond to your question. Over the years, have bought many materials off established relationships fm many vendors. Glad to get you connected if you let me know what materials you are looking for. Where are you located since shipping is part of the calculus.

Look fwd to hearing from you.
Rico